office (713) 849-3366
fax (713) 849-3654
toll-free (800) SAY-AAAT

Fig. 587 Adjustable Beam Clamp


beam clamp APPLICATION:  Fig. 587 Adjustable Beam Clamps are recommended for use in suspending hanger rods from the center of overhead support beams.
The support members are I-beams or wide flange beams with a flange width from 3 ½” to 8” and a flange thickness up to ½”.
CONSTRUCTION:  A Fig. 587 Adjustable Beam Clamp consists of one bent flat bar and one bent rod as shown in the diagram above.
One end of the flat bar is bent to hook around the flange member and the one end of the rod is bent to hook around the other edge of the flange member.
The flat bar and rod are made of carbon steel.
FINISHES AVAILABLE:  Black, Hot Dip Galvanized or Electro-Plated.
ORDERING:  Specify figure number, rod diameter, name and finish, if other than black.

beam clamp chart